Everbuild WOODWORM KILLER Low Odour Wood Treatment low Solvent 5L

Description

Everbuild Woodworm Killer | Low Odour Wood Treatment | Low Solvent | 5L
Everbuild Woodworm Killer is a ready-to-use treatment for the eradication of all types and life stages of wood-boring insects and their larvae, specifically woodworm. It is a low solvent; low odour solution based on Micro-fine active technology with added insecticide to penetrate deep into the wood to actively kill and protect against re-infestation.
Everbuild Woodworm Killer is fast drying and non-flammable.
Benefits
Kills all types of wood-boring insects.
Penetrates deep into the wood for long-lasting protection.
For interior use only.
Over paintable.
Areas for use
Can be used on most internal furniture, woodwork and joinery such as doors, window frames, roof timbers, floorboards, joists, rafters, etc.
Can be overpainted, stained, varnished, or polished when dry if required.
Limitations
Ready to use - do not dilute.
Do not use in food preparation areas.
Do not use externally.
It is the user’s responsibility to determine suitability for use. If in doubt, contact the Technical Services Department for advice.
Surface Preparation
Ensure that timber to be treated is clean.
Any paint or other surface coatings should be removed prior to application.
Remove any badly infected or structurally unsound timber and replace with sound timber prior to application.
Application
Read statutory conditions relating to use prior to application.
Shake well before use.
Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying.
The second coat should be applied after the first coat has soaked in but before it is dry.
Pay particular attention to thoroughly soaking the end grain.
Where possible, dip or flood the end grains of the timber for maximum protection.
Coverage Guide
Apply 2 coats at a rate of 1 litre of product per 3 - 4m² of the surface.
Dip end grains for a minimum of 3 minutes or flood thoroughly where dipping is not possible.
Drying time is approximately 1 hour depending on temperature.
Everbuild Woodworm Killer is a ready-to-use treatment for the eradication of all types and life stages of wood-boring insects and their larvae, specifically woodworm. It is a low solvent; low odour solution based on Micro-fine active technology with added insecticide to penetrate deep into the wood to actively kill and protect against re-infestation. Can be used on most internal furniture, woodwork and joinery such as doors, window frames, roof timbers, floorboards, joists, rafters, etc. It is the user’s responsibility to determine suitability for use. If in doubt, contact the Technical Services Department for advice. Remove any badly infected or structurally unsound timber and replace with sound timber prior to application. Dip end grains for a minimum of 3 minutes or flood thoroughly whe